front driveshaft question

[JERSEY99XJ]

when i replaced my engine i pulled the trans and transfer case with it. therefor i had to remove the driveshafts. when i put the new engine in both shafts were short. the rear i bolted in and it stretched back out so i figure the front is the same way. but i cant get it to work. does anyone knwo any easy to bolt the front shaft up? thanks

 

[St3mpy]

Umm, I'm not sure I fully understand the question. Putting in driveshafts shouldn't be hard at all.

 

[bajacalal]

Are you talking about the slip yoke of the driveshaft. The rear slips "in and out" at the tail of the transfer case and the front has a slip connection in the center. You can pull the two halves further apart.