DeftwillP
NAXJA Forum User
- Location
- Round Rock TX
I stumbled across these pistons for cheap on ebay:
http://cgi.ebay.com/ebaymotors/ws/e...tem=7985286842&category=33623&sspagename=WDVW
They have a 3.875 bore though I can't seem to find pin dimensions and heighth. There seems to be a lot of pistons in 250 engines of different builds that are of this exact build. Check this list:
http://users.erols.com/srweiss/tablersn.htm
It doesn't seem impossible that there would be a piston in STD, 30, or 60 over that would be forged and be of the right height to run the favorable 4.0 rod.
I may be speaking out against research thats already been covered here, but I'm just checking.
Will
http://cgi.ebay.com/ebaymotors/ws/e...tem=7985286842&category=33623&sspagename=WDVW
They have a 3.875 bore though I can't seem to find pin dimensions and heighth. There seems to be a lot of pistons in 250 engines of different builds that are of this exact build. Check this list:
http://users.erols.com/srweiss/tablersn.htm
It doesn't seem impossible that there would be a piston in STD, 30, or 60 over that would be forged and be of the right height to run the favorable 4.0 rod.
I may be speaking out against research thats already been covered here, but I'm just checking.
Will
