Engine Stand for Trade

[Chip Clip]

Engine stand - Let me know what you have.

 

[Chip Clip]

No one needs this?

 

[Brandon77]

I could use it... what u looking for?
What's the manufacture and weight limit?

 

[Chip Clip]

I believe it is 750, what do you have?

 

[Skwerly]

I'm looking for one, but the three leggers make me nervous... is it pretty sturdy? I need it for a small block V8.

 

[GrimmJeeper]

I'm looking for one, but the three leggers make me nervous... is it pretty sturdy? I need it for a small block V8.

i had a 4.3l on the one I have, it looks to be the same one as this. it was scary but it held up ok enough for me to tear the motor down to a bare block and rebuild it.

 

[Skwerly]

Yea, lol, hmm... These aren't that much I may hold out for a four-legger. I'd feel a whole lot better I believe.

 

[JohnX]

It would only take ten minutes and ten dollars to make it a four legger??? Just a thought.

 

[Chip Clip]

Still have this. Will trade for some good 1"coil spacers.

 

[greenchevy]

i have 2" coil spacers. do you have anything else?