mfascuba
NAXJA Forum User
- Location
- North Central Florida
Anyone replaced these in the garage? Last time I had a diff go was on a one ton truck, cost me $600, but that was fifteen years ago.
My thought (idea...) is to pull the carrier, replace the bearings and reassemble it with the same spacers that came out of it, put back in just like they were. It's the front axle we're talking about, I think I've narrowed down the noise to the diff.
Bottom line, I want to try a swap out of bearings without going thru the setup again. The pinion seems fine, seal doesn't leak, etc.
Whatch'all think??
Mark
My thought (idea...) is to pull the carrier, replace the bearings and reassemble it with the same spacers that came out of it, put back in just like they were. It's the front axle we're talking about, I think I've narrowed down the noise to the diff.
Bottom line, I want to try a swap out of bearings without going thru the setup again. The pinion seems fine, seal doesn't leak, etc.
Whatch'all think??
Mark