ComforableInChaos
NAXJA Forum User
- Location
- Pike County, Georgia
Okay so i had an apiffiny.
What if you got two pieces of square tubing.
One slightly smaller to fit inside the other.
You Welded these to the U Joints of your stock
driveshaft. You would have a drive shaft that could
change lengths. The only Con to this idea i see maybe
some bad vibes? You would have to make it strong though.
any thoughts?
i could possibly be a complete idiot. No doubt
What if you got two pieces of square tubing.
One slightly smaller to fit inside the other.
You Welded these to the U Joints of your stock
driveshaft. You would have a drive shaft that could
change lengths. The only Con to this idea i see maybe
some bad vibes? You would have to make it strong though.
any thoughts?
i could possibly be a complete idiot. No doubt