builder
NAXJA Forum User
- Location
- Yucca Valley california
Who else besides tnt builds custom control arms? thx
custom control arms
- Thread starter builder
- Start date
Gaius
NAXJA Forum User
- Location
- Beaverton, OR
Clayton will build you any length I believe, and so will a lot of shops like BTF.
Benjisaurus
NAXJA Forum User
- Location
- Tennessee
Rusty's does custom arms too, but check out Clayton if you have a little extra $$...really good stuff...the square tubing was a little odd to me at first, but it makes sense.
Gaius
NAXJA Forum User
- Location
- Beaverton, OR
They are real easy to make yourself. Even take a class at the local CC and make them there.
Here's my short arms for my XJ:
Here's my short arms for my XJ:
bigjeep913
NAXJA Forum User
- Location
- georgia
PM sent...
selarep
NAXJA Forum User
- Location
- Central CA
wow nice arms! Jonny joints and all! good work, what kind of rubber is that? amd wall thickness on the tubes?
bigjeep913
NAXJA Forum User
- Location
- georgia
I make them also, like someone said, they arent that hard if you have decent welding/fab skills, these are 2" 1/4" wall DOM with summit flex joints on both ends and made for a 4.5" lift. they are taken apart cause they were just painted
aparke4
NAXJA Forum User
- Location
- Atlanta, Ga
thats some good fab right there in both instances - cool!
Gaius
NAXJA Forum User
- Location
- Beaverton, OR
selarep said:
Thanks. It's stock Jeep bushings on one end using Rubicon Express Cold Cut end rings, 2x.25 square tubing (trailer hitch tubing), a round tubu adapter from Poly Performance, and the Large 1.25 inch shank Johny Joint. It might be a littl over board, bit it was left over parts from my TJ build. I had planned on long-arming the XJ, but decided to just make short arms. I can always cut, sleeve, and extend the tube to lengthen them.
My custom uppers:
