4x4JeePmaNthINg
NAXJA Forum User
- Location
- Colorado
Re: The Colorado BS thread
I've always wanted one of those train horns for those fun occasions.
I've always wanted one of those train horns for those fun occasions.
Colorado B/S Thread
- Thread starter in4aride
- Start date
- Location
- Golden, CO
Re: The Colorado BS thread
I think he was scared enough looking up to see my bumper aimed at his door. He drove 25 mph in a 35 mph until I turned at the next light. I was OK with that.
:laugh:
I think he was scared enough looking up to see my bumper aimed at his door. He drove 25 mph in a 35 mph until I turned at the next light. I was OK with that.
DutchVDub
NAXJA Forum User
- Location
- Milliken, CO
Re: The Colorado BS thread
Selling off my ‘88 Ford HP D60 kingpin front, stock 4.10’s open, and 8x6.5 Sterling 10.25 of anyone here needs some tons.
Selling off my ‘88 Ford HP D60 kingpin front, stock 4.10’s open, and 8x6.5 Sterling 10.25 of anyone here needs some tons.
freerider15
NAXJA Forum User
- Location
- FoCo, Crawlorado
Re: The Colorado BS thread
Going a different direction in the buggy?
Can't remember what you said you were planning on running axle wise.
Going a different direction in the buggy?
Can't remember what you said you were planning on running axle wise.
DutchVDub
NAXJA Forum User
- Location
- Milliken, CO
Re: The Colorado BS thread
I snatched up Chris’ 79 D60/D70 combo already with 4.88’s and Detroits
I snatched up Chris’ 79 D60/D70 combo already with 4.88’s and Detroits
time2getdirty
my cats breath smells
- Location
- Cheyenne, Wyoming
Re: The Colorado BS thread
4.56s I thought?
4.56s I thought?
freerider15
NAXJA Forum User
- Location
- FoCo, Crawlorado
Re: The Colorado BS thread
Oh nice.
I've got some Solid Axle Inner Cs for sale to make that D70 rear steer
Oh nice.
I've got some Solid Axle Inner Cs for sale to make that D70 rear steer
trippled
NAXJA Forum User
- Location
- colorado springs, co
DutchVDub
NAXJA Forum User
- Location
- Milliken, CO
Re: The Colorado BS thread
He told me 4.88's but either way will work just fine for the buggy and the 3 speed t-case setup
I think there will be a big enough learning curve with the buggy as is, no need to jump straight onto the deep end right away. I'll be happy just to take the floaties off once its done lol.
PM sent
He told me 4.88's but either way will work just fine for the buggy and the 3 speed t-case setup
Oh nice.
I've got some Solid Axle Inner Cs for sale to make that D70 rear steer
I think there will be a big enough learning curve with the buggy as is, no need to jump straight onto the deep end right away. I'll be happy just to take the floaties off once its done lol.
PM sent
4x4JeePmaNthINg
NAXJA Forum User
- Location
- Colorado
Re: The Colorado BS thread
Any of you guys ever try running rottela T6?
Any of you guys ever try running rottela T6?
Re: The Colorado BS thread
I use it in my 2500 diesel. It costs about $10 less per gallon at Wal-Mart than the auto parts store at about $20 a gallon vs $30. I've used it in my Hemi when I forgot it takes 7 quarts not 6 on oil changes and because I was short on cheap stuff and needed to top off my generator I've been topping the predator generator off with that gallon for awhile . It's thin enough so it should work fine on most engines , but it's not really any cheaper than using mobile1 synthetic .
I use it in my 2500 diesel. It costs about $10 less per gallon at Wal-Mart than the auto parts store at about $20 a gallon vs $30. I've used it in my Hemi when I forgot it takes 7 quarts not 6 on oil changes and because I was short on cheap stuff and needed to top off my generator I've been topping the predator generator off with that gallon for awhile . It's thin enough so it should work fine on most engines , but it's not really any cheaper than using mobile1 synthetic .
Re: The Colorado BS thread
Lol... got cut off on c470 by a Mercedes I was in the slow lane poking along at 65 about 2 seconds after he cut over leaving me short room he whips it back into the center lane with no warning and I spot a prairie dog in my lane , which he was dodging, so I encroach on the shoulder white line since mr.prarie dog was doing his straight statue pose like he's invisible and as I moved right he unfrozen and moved right so I stopped and then froze again and , well too late...thump... I could have served into the middle lane but traffic didn't permit and it would have possibly caused a wreck ...So few seconds after the Mercedes passenger throws me the thumbs down sign...lol... guess it's better to whip your Mercedes into a traffic lane with no signal or warning to possibly kill other motorists to avoid mr.prarie dog...? Lol
Lol... got cut off on c470 by a Mercedes I was in the slow lane poking along at 65 about 2 seconds after he cut over leaving me short room he whips it back into the center lane with no warning and I spot a prairie dog in my lane , which he was dodging, so I encroach on the shoulder white line since mr.prarie dog was doing his straight statue pose like he's invisible and as I moved right he unfrozen and moved right so I stopped and then froze again and , well too late...thump... I could have served into the middle lane but traffic didn't permit and it would have possibly caused a wreck ...So few seconds after the Mercedes passenger throws me the thumbs down sign...lol... guess it's better to whip your Mercedes into a traffic lane with no signal or warning to possibly kill other motorists to avoid mr.prarie dog...? Lol
DutchVDub
NAXJA Forum User
- Location
- Milliken, CO
Re: The Colorado BS thread
Both of my Audi S4's and my 2001 Ford 7.3L PSD get nothing but Rotella T6
Both of my Audi S4's and my 2001 Ford 7.3L PSD get nothing but Rotella T6
DutchVDub
NAXJA Forum User
- Location
- Milliken, CO
Re: The Colorado BS thread
LOL, I just ran over a Prairie dog with my new Indian. Barely felt a thing.
LOL, I just ran over a Prairie dog with my new Indian. Barely felt a thing.
YELLAHEEP
NAXJA Forum User
- Location
- Littleton, Colorado
Re: The Colorado BS thread
Dutch...... buggy?
Dutch...... buggy?
xj-grin
NAXJA Member #1096
- Location
- Colorado Springs, Colorado
Re: The Colorado BS thread
4.88 -- you were looking for 5.13 (which is what I thought they were when you were considering them, T2GD).
4.88 -- you were looking for 5.13 (which is what I thought they were when you were considering them, T2GD).
DutchVDub
NAXJA Forum User
- Location
- Milliken, CO
Re: The Colorado BS thread
Yeah. Building a JHF/Goatbuilt 4 seat chassis. Very slowly I might add.
Yeah. Building a JHF/Goatbuilt 4 seat chassis. Very slowly I might add.
4x4JeePmaNthINg
NAXJA Forum User
- Location
- Colorado
Re: The Colorado BS thread
:soapbox::flamemad:
Car diagnostic run, p1391, 99% the pcm is throwing the code for no reason.
Cam and crank sync up, scope is clean. Signal is getting to the PCM.
They suggest flashing/update it at the dealer maybe before looking for replacement.
:soapbox::flamemad:
Car diagnostic run, p1391, 99% the pcm is throwing the code for no reason.
Cam and crank sync up, scope is clean. Signal is getting to the PCM.
They suggest flashing/update it at the dealer maybe before looking for replacement.
- Location
- Golden, CO
Re: The Colorado BS thread
Mr. Denard, will you ask Sam to reply?
A guy who posts here now and again might be able to flash your ECU.
Mr. Denard, will you ask Sam to reply?
freerider15
NAXJA Forum User
- Location
- FoCo, Crawlorado
