Clifford 4.9L Jeep motor, Built D60s

[Prepmech]

Building some new buggies, the old stuff has to go.

Clifford 4.9L I6
custom rods
roller rockers
custom clifford head
jacobs ignition
intake/carb included
over 300 hp, and tons of torque at low rpm
allowed for roll on wheelies when in a CJ7
Very few were ever built by clifford, all original documentation included
Over $12,000 new
Asking $5000

Dana 60 HP front axle
complete
kingpin knuckles
new everything
detroit locker
4.88 gears
Rock Krawler long arm/coilover brackets
solid cover
hd pinion yoke
shaved and skidded
Full width

Dana 60 rear axle
61" wide
4.88 gears
yukon shafts
spool
shaved and skidded
hd yoke
disc brakes
solid cover
set up for triangulated 4 link and coilovers, bridge has been removed

$2,200 for pair

 

[PurpleCherokee]

I wanna know how much torque that baby's puttin out...

 

[CV95XJ]

im kicking myself right now, If I hadn't just bought some dana 44's, I would be all over these 60's.

 

[Prepmech]

We aren't really sure, the dyno was acting up when it was ran

I think it was somewhere around 350, but the next motor that was ran turned numbers that were a lot lower than usual

They keep joking that it broke the dyno

I don't know if any of the others were put on a dyno or not

 

[Prepmech]

That is a killer deal on the 60s, looking to move them quick.

 

[PurpleCherokee]

We aren't really sure, the dyno was acting up when it was ran

I think it was somewhere around 350, but the next motor that was ran turned numbers that were a lot lower than usual

They keep joking that it broke the dyno

I don't know if any of the others were put on a dyno or not

Those things are torque MONSTERS lol... if I only had the money. But then again isn't that just the way it goes...

 

[CV95XJ]

I got a buddy that might be looking for axles, I'll talk to him tomorrow

 

[HaleYes]

I know a guy that just bought a tube buggy. Those would axles would go great under it.

Rockwells, Schumckwells

 

[MXJ]

The 60's have been sold.