camber angle problem

[rtaboada]

hi, my xj have d44 front and 235/75 R 15, no lift

and the camber angle it's very negative

this problem have solution?

thanks!!

Rodrigo

 

[vintagespeed]

Um yeah, STOP JUMPING IT! That's about the only cure for this problem.

The only way to FIX it is to find an old-time alignment shop that will heat & bend the tubes back where they should be. You can also try offset balljoints to adjust camber, but I doubt you'll get enough.

Good luck!

 

[JEFF]

Off set upper ball-joints is probably the best option, but I think the most off-set you can get is 1.5 degrees. If this dosn't fix it and the axle is bent that bad you may want to start looking for a new axle housing. A severly bent axle will also abnormaly wear carrier bearings and gears, this is also something to keep in mind. Also you may want to !!!!!STOP JUMPING IT!!!!! Good Luck

 

[rtaboada]

ja ja ja ja OK OK, stop Jumping , thanks for the answers

Rodrigo :angel: