Any performance aluminum driveshaft for XJ?

[hawk_sixsix]

I'm looking for a stronger/lighter performance driveshaft; something like what's installed on Camaros/Firebirds/Mustangs (where most of my experience lies). Stronger shaft, less rotational weight.

Also, can anyone recommend good U-joints?

97 XJ w/ AX-15 with Dana 30 front, 8.25 rear

 

[GrimmJeeper]

I would talk to your local driveline shop, you are probably going to have to have one custom made. AFAIK there is no off the shelf direct replacement for the original shaft, there is not enough aftermarket racing interest in the XJs.

 

[CherBear]

I'm looking for a stronger/lighter performance driveshaft; something like what's installed on Camaros/Firebirds/Mustangs (where most of my experience lies). Stronger shaft, less rotational weight.

Also, can anyone recommend good U-joints?

97 XJ w/ AX-15 with Dana 30 front, 8.25 rear

Im guessing it would have to be custom made. Unless you can find one in a similar length from a different application.

 

[Dr. Dyno]

The Mustang aluminium driveshaft is definitely too long but it'll work if you can get it shortened and rebalanced.

 

[RedChuck]

you could always get ends mounted to a carbon fiber tube :thumbup:

 

[yossarian19]

you could always get ends mounted to a carbon fiber tube :thumbup:

Yes, but for about the same cost you could buy something a thousand pounds lighter with IFS...:gag:

 

[haneyXJ]

Very cool idea, I'll bet your local driveline shop would be all over it if they have aluminum capabilities (i'm thinking welding). they would charge the hell out of it too.

Also, can anyone recommend good U-joints?

Try spicer replacements! (spicer part #5-153x last I knew) or if you have money buy CTM! hehe

 

[Magus2727]

I think Tom Woods makes a good Alum drive shaft.

 

[Talyn]

Most large drive shaft shops make aluminum shafts. I've personally used Denny's and had great results. http://www.dennysdriveshaft.com/