MoparManiac
NAXJA Forum User
- Location
- Amherst, NH
And here's where it broke.
98XJ: Project Salsa
- Thread starter XJLI
- Start date
XJLI
NAXJA Forum User
- Location
- Long Island, NY
thats cut back WAY more than mine is
MoparManiac
NAXJA Forum User
- Location
- Amherst, NH
Get a better pic if you can Adam.
I know the bottom part of the casting is there, but it doesn't mean jack if the top is cut all the way back to the plug welds (aka where mine was).
I know the bottom part of the casting is there, but it doesn't mean jack if the top is cut all the way back to the plug welds (aka where mine was).
ktm racer 419
NAXJA Forum User
- Location
- ROW DIALIN
i wouldnt skydrive that.
XJLI
NAXJA Forum User
- Location
- Long Island, NY
wah.
it'll be fine.
it'll be fine.
- Location
- Rainy side of Washington
last time this was said, a home built jet engine blew up and set my entire lower arm on fire a minute later.
Just sayin' :laugh2:
Begster
NAXJA Forum User
- Location
- Cape Cod/Boston, Mass
DeNile is not just a river in Egypt...
foxwar71
NAXJA Forum User
- Location
- Foxboro, MA
XJLI
NAXJA Forum User
- Location
- Long Island, NY
i like explosions
mini=man
NAXJA Forum User
- Location
- Neh Hampshuh
FIRI. You'll be wheeling be wheeling before any of those clowns anyways.
- Location
- Rainy side of Washington
your oil pan is commiserating with his 44My 60 truss and cut housing are laughing at yours
foxwar71
NAXJA Forum User
- Location
- Foxboro, MA
Nah dude, my truss isnt that bad. A TNT HP60 truss stands higher off the top of the center section then mine. I dont know how it compares to the middle of the axle though. Worse comes to worse, I have no problem about cutting/trimming the center of mine for clearance.
Begster
NAXJA Forum User
- Location
- Cape Cod/Boston, Mass
Incorrect, I'm still wheeling. I was going to go last weekend but Sam didn't hear back from the land owner, and said the 2 hour drive wasn't worth it for the other trails they were going to.
ktm racer 419
NAXJA Forum User
- Location
- ROW DIALIN
im gonna try to get out there after the mid-april rc run. ill let you know
Begster
NAXJA Forum User
- Location
- Cape Cod/Boston, Mass
Thank you kind sir.
XJLI
NAXJA Forum User
- Location
- Long Island, NY
getting knuckles from tim.
hes the man.
hes the man.
mini=man
NAXJA Forum User
- Location
- Neh Hampshuh
XJLI
NAXJA Forum User
- Location
- Long Island, NY
ugh i wish. this truck will have some stupid bling beadlocks on it eventually.
mini=man
NAXJA Forum User
- Location
- Neh Hampshuh
Yeah I was hoping they had them in 8x6.5, but no dice. But honestly, I'd be afraid of tearing the center out of them.
No thanks Mister.:shiver:
No thanks Mister.:shiver:
Last edited:
- Location
- Rainy side of Washington
They look really pretty but I don't pay that kinda mad bling moneys for rims with no beadlocks on em
Similar threads
