Techyon
NAXJA Forum User
- Location
- Pittsburgh Pa
Ok,
Its got the 4.0 liter, 110 k miles,
Now the problem has become its stalls everytime it starts to idle.
Its not everytime its completely intermitant.
So say I'm driving down the road doing 35, let off the gas and start to coast, it sometimes stalls, and also at red lights, No warnings no spits sputters just dies.
Ok it will restart "when its ready" today it did it 5 times on a 28 mile trip, longest time I had to wait was 10 minutes, during that time I tried to test for spark. I had NONE.
45 seconds later.. it started up and made it 4 miles home.
Ok, I've replaced within the last 4 months the
TPS - Throttle position sensor
IAC - Idle Air Control
ICM - Ignition Control Module
Coil
Crankshaft position sensor
Cap, rotor, plugs and wires
So anyone who can be of some help would be GREATLY appreciatted.
I'm baffled now, I had someone help me on here before when I had bathed the engine bay and drowned the ICM, I replaced it then with a working junkyard pull. As well as the TPS.
SO its been since then it ran "ok" this month Ive bought everything again with the exception of the Crankshaft position sensor, that was also last summer when trying to find why I had lost spark due to water.
Its a renix jeep, so is there any way to get a scan tool to talk to this jeep?
Thanks,
Techyon
Its got the 4.0 liter, 110 k miles,
Now the problem has become its stalls everytime it starts to idle.
Its not everytime its completely intermitant.
So say I'm driving down the road doing 35, let off the gas and start to coast, it sometimes stalls, and also at red lights, No warnings no spits sputters just dies.
Ok it will restart "when its ready" today it did it 5 times on a 28 mile trip, longest time I had to wait was 10 minutes, during that time I tried to test for spark. I had NONE.
45 seconds later.. it started up and made it 4 miles home.
Ok, I've replaced within the last 4 months the
TPS - Throttle position sensor
IAC - Idle Air Control
ICM - Ignition Control Module
Coil
Crankshaft position sensor
Cap, rotor, plugs and wires
So anyone who can be of some help would be GREATLY appreciatted.
I'm baffled now, I had someone help me on here before when I had bathed the engine bay and drowned the ICM, I replaced it then with a working junkyard pull. As well as the TPS.
SO its been since then it ran "ok" this month Ive bought everything again with the exception of the Crankshaft position sensor, that was also last summer when trying to find why I had lost spark due to water.
Its a renix jeep, so is there any way to get a scan tool to talk to this jeep?
Thanks,
Techyon