Recent content by s10er8

$250

I have a d70 w/4.10 gears out of an 70's f350 single rear wheel 35 spline shafts

2 left. get 'em while they last I need a dana 300 right now and would trade even for one if it has a twinstick shifter

I have a drivers side kingpin 60 w/30 spline outers spicer hubs and welded spider gears 4.10 ratio. Want to trade it for your passengers side drop kingpin 60 Those brackets are cut off except for the hydro assist bracket, the axle tubes need cleaning up from cutting the brackets off

That axle is sold

The axles are open differential 4.10 gears, the brakeline bolts directly on. I will give you weld-on shock tabs to mount the shocks. The perches are in the exact spot and the pinion angle looks good. The trucks these came out of are low mileage also so these axles are in good shape. Low as in...

Re: SEC Chapter KARMA thread D35 3.55 rear axle from 89 MJ. I'm pretty sure I checked it and it has semi float shafts. You can check out my XJ build while you're here. dana 60's on 38.5 swampers If you get here before I take my scrap metal pile off theres parts you may could use in it. a...

Also have a 60 rear w/3.55 gears and a posi $100

3 left

They are Dodge axles. John the 44's are 8 lug

HP Dana 30 vacuum disconnect 3.55 gears complete pulled from running vehicle $60 Dana 35 from an MJ spring under perches 3.55 gears no brakes/drums/brake hardware $30

They about 5 inches wider than stock and are 8 lug bolt pattern. I'm putting one underneath my XJ, I havent connected it yet but the brake line falls in the same exact location and looks like it is going to connect right up I'm making a run towards Atlanta from Augusta saturday morning and can...

I have 5 Dana 60 rears that bolt right onto XJ leafs 4.11 gears/full float/30 spline 65.5" wide $250 each

Beef it up/plate it

Chad whay do you need? I probably have the parts if not we'll get them from the jy