Recent content by mjdavis31

I went with the terraflex kit I paid for it but I like it.

Who has time to wait for a window to get down... hahaha but really ive googled it and searched on here Im lookin to make my windows fast in my searches ive found you can lubricate the tracks :shocked:... and I might look into relays direct from the batteries but out prefer to just spend some...

i welded the sender off of the 96 xj to the upper part of the sender for my mj and hooked it up and it works great but no fuel level i got in a rush you can do the dakota tank thing and it has the same style fuel system. in gonna get a fuel cell and a pump out of sumit one of these days.

Fuel pump wont work if your engine is the 96 as well its a single fuel line and internally regulated in 96. also i never figured the right was to wire the tail lights with the 96 steering column so the brake lights would intterupt the turn signal when its on i did go down to wal mart and get a...

So ill start with a little history a year ago i installed a 91 4.0 and an ax 5 i bought an entire jeep for 200 bux so i figured why not i got it in fine and ran it for awhile recently it blew the head gasket near the same time a friend of mine picked up a wrecked 96 cherokee with nice int. and a...

Thanks for the info I wrecked out a 91 4.0 cherokee to do the swap the only thing i forgot (that i know of so far) was the frame mounts the fuel lines back to the tank and the trans mount plate. went to the bone yard and got the mounts and mounted the engine tearing out the harness today.

I pulled the engine out already i went to put the 4.0 and trans in together and the thing would not get back far enough to get on the mounts it was late so i just tied it up and called it a night. this morning i went out and looked and my 4.0 xj and it seems the mounts sit farther foward the...

stick a screw driver across the terminals on the top of the starter cylinoid carefully make sure its in park or out of gear. poss. causes if the engine cranks: igniton switch or neutral safety switch those are the two must likely failures. try moving the gear shift arround and try to start...

I have a 88 MJ with a 2.5 it was 2 wheel drive 4 speed i found a 5 speed and a 207 t-case i have a t-case shift linkage out of a 99 ish cherokee but the links are too long probaly due to a longer t-case also the handle end hits the top of the t-case when down in the 2 wheel drive poss so i was...

You need to re plumb it go from trans out into cooler then out of cooler into rad. then back to trans. (or rad then cooler) but t-fittings will not work.

i am wondering if any one knows the running length of there control arms with a 6" lift i picked up a good set of coils for cheap so i just sprung over my comanche and i am going to lift the front tomarrow lower control arms out of a dodge are almost the same but 3" inches longer i think they...

any kind with short arms that bolt in the factory location

how much longer are the control arms that come in a 6" inch lift kit compared to stock.

he proly didn't pe-load the pinion right and took out the bearing, causing what would feel like a driveline vibe. did you take your driveline down and have it balanced and inspected?

I'm looking for info from someone experenced. I have 2 T-cases one is and amc 231 with the 21 spline input that has a sye and a heavy duty chain in it but my trans is newer and has a 23 spline input and the t case on it has a broken chain and a hole in it. Couldn't i just open them up and swap...