Recent content by MaxxXJ

OK, so I reset all my passwords, but I'll pm you, thanks casey

Got the motor pulled and fenders and everything cut off, but I lost my job shortly after I got the project so I put it on the back burner for a little bit Now then, the tongue weight right now is roughy around 300 lbs according to a bar/bathroom scale measurement so I think I'm going to have...

I have BDS 10" travel shocks on my 4" long arm lift, just under 15" compressed, and they work out perfect for me, coil just falls short of falling out @ full droop

My brother does great in his 2000 TJ with his D44 and trac lock on 33" km2's guess it's all in the driver...

4.5" long arms or short arms? All I could squeeze out of my short arms was 8" travel shocks... Because of bar pin eliminators and stem eliminator thing

Spartan sent me new pins anyway, I installed it in a different axle and installed the axle under my jeep... Long story short Locker works good as intended and no more binding issues. Glad Randy's ring and pinion warrantied it

Lol I built my front bumper with seam pipe, I wouldn't build a roll cage with it but for free pipe I figured why not the rocks don't know any different

I've had this dana 30 locker a short while, I've put maybe 15 trips on it and I trailer it to most places, I don't wheel very hard I'm pretty conservative and don't push my limits... Anyway I have an 89 cherokee on pretty bald 33x10.50's which look the size of new 31's, anyway I went on a easy...

If this wasn't in San Diego id drive to get it... But it won't fix in my honda and my truck gets horrible mileage :)

Specfab I'm a rig welder as well so I understand it's overkill, but I 'd much rather have to weld it once and know it's ok and I put in stronger metal than what's there than to have to do it again later. Most of the time I'll use my flux core buzz box for thin stuff just because I can work the...

Because it's stronger than 6010, and it won't crack as easy due to vibrations like 6010 will. 6010 is actually pretty brittle.

I cracked my chassis at the sway bar mount as well, I threw that pos in the junk pile :) but anyway, because it's super think metal there I just turned my mig welded up a little and started before the crack so heat had a chance to build up, and welded Into the crack all the way to the end, for...

I plan to complete it asap. At least the trailer part and filling the holes the bed section might take a minute since I lost my job on the 4th but I'll do what I can with the material I have already

So I've been searching and searching for basically an empty shell for a little while but everyone either had no title or wanted to much for it Anyway I ended up picking this up, interior stripped motor had a blown head and missing anything that was good. Transfer case gone and transmission isn't...

I have a hp dana 30 front and dana 44 rear, I have 3.55's now and plan to go to 4.88's I'm getting 35x12.50's soon so I need to gear for them, I plan to tow a small camp trailer so idk that 4.56's will be deep enough. Anyway, I have auto lockers front and rear and a carrier for my dana 30 for...