Graeme
NAXJA Forum User
- Location
- Greenwood, Nova Scotia.
I just ordered an Iron Rock Offroad HnT kit with a refurbed front driveshaft.
Just wondering if I have to pull the transfer case out to do the the tapping.
What did everyone use to cut the output shaft? I have a sawzall and an angle grinder and plan just to use that...
And the tapping part. Has anyone drilled and tapped with the TC on the vehicle? How did you ensure the whole went in straight?
Just wondering if I have to pull the transfer case out to do the the tapping.
What did everyone use to cut the output shaft? I have a sawzall and an angle grinder and plan just to use that...
And the tapping part. Has anyone drilled and tapped with the TC on the vehicle? How did you ensure the whole went in straight?