My first regear job opinions,please

[XJ01-08]

My first time so i'd just like to check and see how well I did, Thanks
Dana 30 HP
BL is at .006

 

[Porch951]

Nice work, wish i had done such a good job on my first try!
That said, i would move the pinion a couple thou closer. You're almost there!

 

[XJ01-08]

I wish it was my first try but thats about my third attempt at getting it close, it looked pretty close to me but since it was my first time I thought I should get some insight from those with more expierence.
Thanks

 

[bobnoxious]

That's a good pattern.

 

[jeeperjohn]

It is near perfect, don't go deeper. Good work.

 

[Nealio240z]

looks spot on. I would leave it.

 

[Porch951]

I meant first gear job. I royally botched my first time.
It looks like most of the pressure is towards the outside of the tooth rather than centered in it, but i'm 100% sure that it's close enough to be quiet.

 

[NJblackdeath4x4]

That's the coast side. The drive side is dead center.

 

[Porch951]

I wasn't just talking about the coast side, you can see what i mean on the unpainted teeth.

Whatever, it's good enough, and i'm not going to argue all day over what amounts to an opinion. I would be fine with leaving it on my rig.

 

[jeeperjohn]

The coast side basically means nothing as long as the drive side is good.

 

[XJ01-08]

Thanks guys, hopefully ill get to try it out this weekend if i manage to finish my front crank seal.