montanaman
NAXJA Forum User
- Location
- Western Montana
I'm rebuilding my 231. There is a bearing that is pressed into a hole that can only be reached from the top of the hole.
Here is a pic of what I'm talking about:
It's not perfectly focused, but it's not accessible from the back side. The view you see in the pic is the only point of access. It appears there's not enough gap at the bottom of the bearing to get anything in there to pull it out.
Any ideas? Special tool?
Thanks.
Here is a pic of what I'm talking about:
It's not perfectly focused, but it's not accessible from the back side. The view you see in the pic is the only point of access. It appears there's not enough gap at the bottom of the bearing to get anything in there to pull it out.
Any ideas? Special tool?
Thanks.