rowley65flip
NAXJA Forum User
- Location
- Fort Wayne, IN
I have an 87 xj that i just swapped a 4.0 from a 97 into (had 2.5). I used the AW4 from the 87 and had to switch the trans mounts so the 4.0 would fit. this pushed my trans back about two inches. now my rear drive shaft is too long and my front is too short. Im going to a drive shaft shop tomorrow and need to know the length they need to be shortened and lengthened to. I have an AW4 with a 231 and dana 30/35 with a 1 inch tc drop and 4.5 inch rough country lift. should i go stock lengths for a 4.0? i have looked through every junk yard in my area and have not found any shafts. Also i know a sye is the way to go but im broke. thanks