Search results

For sale: '93 XJ (Country model) 193k, 4.0, AW4, 8.25,good glass, doors, hood, hatchback, mag wheels. Seats and carpet in good condition. note: this car has been striped down for a restoration project due to floor panel rust. It is not drivable due to the gas tank, seats etc... removed. All...

Off hand, anybody know what type sensor it is, titania or zirconia?

Thanks

I'm installing a new ring and pinion in a Dana 44 in an 87 XJ. My tech info is from a 1990 Chrysler/Jeep shop manual, which has a section on Comanche Dana 44's used with the metric ton package(the axles are the same except for location of spring and shock perches). It calls for setting pinion...

I have an OME kit.

Thanks, trying to figure out what size tires will work to get best fuel economy with my new 4.10 gears. Randy's Ring and Pinion book on differentials claims best fuel economy occurs at 30% below max torgue.

Off hand, anybody know the RPM at which the renix 4.0 engine achieves max torque?

I have a silver hatch off a 01 xj, no tint but good defroster, very minor damage on the lower left side. If you're not in too big a hurry for it, I can deliver it and help you install it. My daughter lives in INDY and I'll bring it along the next time I visit her.

My 01 xj build sheet says I have a 181FBI, and it's a low pinion Dana 30. The spec in my 01 xj shop manual for the 186FBI has the same ring gear daimeter as the the 181FBI. I suspect that the 186FBI is the high pinion. Thanks for your help.

I have a 01 xj, and per the build sheet, it has a 181FBI(low pinion Dana 30 front axle). My factory service manual has a dissertation on this axle, but also has a section on a 186FBI. Any body know what a 186FBI is?

I had my gall bladder removed back in may, but it was pretty wimpy compared to what you're going to have. I suspect you'll be out of commission for a couple weeks. Good luck, see you next summer at CO Fest.

Tom, what kind of surgery?

87 xj with aw4.

Any body know what size diode to use on the 2nd gear lock wiring. The right up references one but does not give a spec.

You bet. Let me do a little research into keeping them at the correct temp for the two day drive, probably need some dry ice. When we get closer to the event, we can nail down a quantity. May be I'll bring a block of cheese as well.

I'm planning on coming from Badger land.

I picked up a transmission beam(mine badly bent up)in junk yard and to my surprise the AW4 support structure mount hole are offset from my Renix. Any body know what year that changed(I found the beam laying around a junk yard all ready removed from the car). I suspect I can buy a newer support...

Off hand, any body know the axle ratio used on an 86 XJ with v6 and automatic transmission?

Thanks

Anybody know the link for the write up to keep the AW-4 in 2nd gear?