Recent content by Dunlapx

Thanks for all of that. I did replace the radiator cap and no change. the problem only seems to happen at 55 or above...both fans are working fine if i had an exhaust leak into the head would the exhaust have any tell tail signs of that, or how would i track that down?

First off i am running a 97 xj with the 4.0 and ax15 manual transmission. 3 inch lift with 31x10.5's and about 215k miles on her. About two months ago i started having overheating issues. I would be driving for about 15 to 20 minutes and out of no where the temp gauge would jump from around 210...

Shorty, what would be the best way to figure out if the injector is working properly?

97 xj with 4.0 I have this hideous squeal coming from my engine and during idle there is a bad shake, upon measuring the temps of the cylinders with a laser gauge at the header pipe coming out of the head, i found that the first cylinder(closest to the water pump) is running at 400 degrees, the...

So i was just trying to switch out my shocks and both rear lower shock mounts broke. i have no clue what to do??? i am thinking about drilling them out, but its a pretty big hole, Any Suggestions???

thanks for the feed back, i will take that all in to consideration

So i have recently been looking at getting a Chevy Colorado, any thoughts? Iit is an 07 with 90,000 miles. Also do any of you know where i could find a good place to look for aftermarket parts for Colorado's, something along the lines of a quardratec or something. Thanks alot Danny

So i am trying to replace the rear output shaft seal in my np231 but cant seem to get the shaft out of the housing. there is a shield on the shaft that is not allowing me to remove it. I can't seem to figure out how to get it off and replace the seal that blew yesterday. it is on a 97 xj. Any...

what are the advantages of that???

So i am right in the middle of rebuilding my np231 and i have been doing a whole bunch of reaserch and while looking at the explodes view of parts on different sites i noticed that the np231 is shown with a yoke on the rear output shaft. mine is a spline shaft. I already looked at the case and...

well i agree this is old, but i will chime in too, i'm up in Cedarburg. i seem to see more and more xj's around Milwaukee so it will be nice to get us all on the same page...

So i have done a bunch of searching and not found what i am looking for, so here is the big question. I go down to the red all the time to go climbing, we stay at Miguel's, and on rest days we always take my xj out and do some wheelin, but it seems like from what i have seen on here that there...

ok, i i have had my 3.5 lift on for a year and i finally decided to get a hi-lift jack, so that if i do go flat, i can fix it if my buddies aren't around. but i have never had to jack up my jeep with a hi lift and i was just wondering where to do it. i have all stock bumpers and side panels. so...

I am running a 97 40 with a 5 spd. It shifts fine, but when i down shift, i get a chirping sound that is definently associated with the clutch. just curious if anyone has had this problem. and what i should do?? i think i will problem change the clutch, pressure plate and throw out bearing, but...

this sunday i will be out there around 2ish, and i am tryin to get my buddy to come out there with his xj. so if u want to come, i will be rollin in the white xj with the black rims... Danny