picknpull doesnt care for springs . i drag jeeps out of teh garage all the time on just bare frame rails(with sand on the ground and 4x4x4s under the frame rails ) with the axles in the jeep (dana 35/lp30s) technically it has axles still, and they never seem to care. just call for a flat bed and explain whats up. if youre concerned about dragging a bad tranny or engine you can throush some plywood under it. they wont pay you any extra for coils/leaves on the vehicle. just an idea.
picknpull doesnt care for springs . i drag jeeps out of teh garage all the time on just bare frame rails(with sand on the ground and 4x4x4s under the frame rails ) with the axles in the jeep (dana 35/lp30s) technically it has axles still, and they never seem to care. just call for a flat bed and explain whats up. if youre concerned about dragging a bad tranny or engine you can throush some plywood under it. they wont pay you any extra for coils/leaves on the vehicle. just an idea.
Is this just to get the Jeep out for PnP? If so I also have a suggestion (that worked). Lower the Jeep onto Pallets, then they will drag it up on the truck. Mine had NOTHING under it It worked great.
Mark-
I could actually use a stock rear pack if you have them still and IF Boatwrench does not need them. DD my rig and need to build a bastard pack. I'll put the old set on Karma after done or you can have them back.