- Location
- Westminster, SoCal
ok, I don't have much experience with cast steel (or whatever it is that's used to make the diff housing) and I'm contemplaiting shaving off a bit of it (about 1/4" to 1/2" worth). I'm planning to shave it down to where there is those two triangulating pieces (for reinforcement). Then I iwll fit in a a custom slider underneath.
Anyways, is there anything to keep in mind while shaving? cutoff wheel? gridner wheel? plasma cutter??
Anyways, is there anything to keep in mind while shaving? cutoff wheel? gridner wheel? plasma cutter??
Last edited: