BIGSLVRXJ
NAXJA Forum User
- Location
- Des Moines, Iowa
My TPS input voltage is 4.66 volts whereas it should be 5. I know most people's Renixs over time get bad grounds where the sensors ground so they run auxillary ground wires. My question is where do the sensors ground in the first place? Is it somewhere that isn't accessible? If it is I would like to just try cleaning the ground and seeing if that works first. The other thing is since my input voltage is 4.66 I have my output at 3.85, am I in the ballpark here, or did I go the opposite way I should have? The last time I set it was about a year ago and I was thinking it was .82% or .83% somewhere in there. I think I have a TPS spec page bookmarked somewhere I just have to find it. Also a bad TPS can cause anything from rough idle to backfiring right? Any help would be 'preciated.
Thanks,
Collin
Oh BTW its a...1990 so no C101 connector or whatever.
Thanks,
Collin
Oh BTW its a...1990 so no C101 connector or whatever.
Last edited: