rubiconron
NAXJA Forum User
- Location
- Greenville, MS
I have changed the valve cover on my 88MJ to one from a 99XJ. The old CCV line ran from the top rear of the valve cover to a fitting in the manifold. In the rear of the manifold is a fitting for the MAT sensor.
Here's my question and a picture.
Can I cut and extend (splice) the wires for the MAT sensor and place it in the front of the manifold? This will relocate the CCV to the rear spot on the manifold (where the MAT was located) allowing me to use the factory vent from a 99+ XJ. In the picture below the green is the 99+ CCV line that I placed in the old MAT sensor location and the red is the MAT sensor and connecor that I relocated.
PS: Disregaurd the coolant all over the engine. I think I punctured a hose.
Any potential issues with this???
Thanks,
Ron
Here's my question and a picture.
Can I cut and extend (splice) the wires for the MAT sensor and place it in the front of the manifold? This will relocate the CCV to the rear spot on the manifold (where the MAT was located) allowing me to use the factory vent from a 99+ XJ. In the picture below the green is the 99+ CCV line that I placed in the old MAT sensor location and the red is the MAT sensor and connecor that I relocated.
PS: Disregaurd the coolant all over the engine. I think I punctured a hose.
Any potential issues with this???
Thanks,
Ron