JeepManDan
NAXJA Forum User
- Location
- Roseburg, OR.
Hey guys, Long story short, I tried a little mud hole, sucked some water into my motor, blew it up, and just put a new engine in my cherokee and it's not anywhere near running right, and this has me stumped.
The "new" motor is a non-high output out of an 89 cherokee. I tore it down and went through it. I used the block, head, crank, and cam from the 89 and then the intake, exhaust, and all the electricals from my 92 cherokee.
Now i've checked the ignition timing, and cam timing. Sometimes it will start up and run, but it runs extremely rough. I'm leaning towards it being a sensor of some sort that went bad from being submerged under water when it blew up. The water level was just over the bumpers.
If anybody has a clue as to whats going on, i would greatly appreciate it! Thanks
The "new" motor is a non-high output out of an 89 cherokee. I tore it down and went through it. I used the block, head, crank, and cam from the 89 and then the intake, exhaust, and all the electricals from my 92 cherokee.
Now i've checked the ignition timing, and cam timing. Sometimes it will start up and run, but it runs extremely rough. I'm leaning towards it being a sensor of some sort that went bad from being submerged under water when it blew up. The water level was just over the bumpers.
If anybody has a clue as to whats going on, i would greatly appreciate it! Thanks