New to me MJ and my first one!

[SBpunk]

Just picked up a new rig. Don't pay attention to the stickers. Its getting sanded down and hit with a light coat of liner in the next few days.

 

[Comanchedude]

Nice! I like it a lot .. Bad Ass

 

[Ian Christiansen]

Can you post some pictures of the truss/bracketry that is on top of the front diff. Is that truss/bracketry part of the Skyjacker kit?

 

[XJEEPER]

Nice!

 

[89eliminator]

looks clean!

 

[SBpunk]

Cleaned out the interior and the engine today. Got about halfway done before the wife started yelling.

Thats the pre engine clean

 

[SBpunk]

Alright got my floor boards done (will add pics later) and my seat finished. This was a pain. The bolts holding the seat to the floor came out so I had to run to the hardware store and get new ones for the 4 going into the frame. For the four others I grabbed some grade 8 big bolts I had laying around and did the inside with those. One of the damn bolts over the frame wouldnt come out so I ended up welding a nut to it and pulling it that way. Seats back in and its driveable again. After all that I pulled the front dif cover finally. The PO left about half the bolts loose when I bought it and I didnt notice it until I drove 20 miles back home. Still had plenty of grease in it though so should be alright.

Ordered 135amp alt and all the supplies (http://www.cherokeeforum.com/f51/zj-136a-alternator-into-4-0-renix-xj-109847/) new fuel injectors, CB radio / PA / dual 4' antenna and other misc crap for it.