Locals to schamburg IL area..

X

x91evo

NAXJA Forum User
Location
naxja sucks dick
Would anyone be willing to let me do a quick PCM swap?
Car is cranking, but not running under its own power. And after getting some funky ASD relay voltage readings, I suspect it is the PCM.

If anyone can help me out I would greatly appreciate it!
I will do all the work, you can kick your feet up and drink beer :roll:
 
Oh should probably add its a 2000,
Not sure what other year PCMs would work with it.
But like I said just need a quick couple of minutes to try and crank!
 
Measured voltage at the ASD relay pins and voltage is low.
Which I'm thinking would indicate either a bad signal from the PCM or a break in the wire somewhere.
 
What terminal is showing low voltage and when? Are you throwing any codes? One terminal is hot at all times (D2). another hot only when key on (D4). The PCM supplies the ground to close the relay at (D6)... (D8) is output. So you could ground D6 and do what the computer is supposed to.

Also D2 and D4 are fused so I would check thouse out as well.
 
Last edited:
I tried using a jumper. I think my problem is more complex in terms of the computer being out of wack (for a lack of a better term)
Just would like to confirm before dumping more money that I dont have.
 
Been over this car at least 3 times this past week.

Posted numerous threads about it on numerous forums, did all the testing, replaced the common problem causers, and nada.
(check my threads started history)

Hoping somebody will let me use their PCM soon!
 
Have you checked the junk yards? They usually have good PCMs most of the vehicles in there were at least running before an unfortunate accident displaced them there. Can't be too expensive. Just a thought.
 
Good idea!
I have and nobody local has one believe it or not.
Thats why instead of buying it online and waiting, I was trying to see if I can at least be sure I need one!
(I am unemployeed currently not alotta $$ to go around)
 
Last edited:
Last edited:
You must log in or register to reply here.

Similar threads

J
No power to interior no signal to obd2
Replies
2
Views
273
Jamesxjrebuild
J
D
No start, no 5v power to cam sensor, about to give up….
2 3
Replies
42
Views
2K
armenbag
A
X
98 Cherokee crank no start
Replies
8
Views
849
HRXJ
H
J
Down to a few electrical issues.
Replies
3
Views
453
Jay Ratliff
J
E
Fuel Pump Wont Stop Priming, CEL not working PLEASE HELP!!
Replies
18
Views
3K
fahadwizz
F
Back
Top