F.N.G.
NAXJA Forum User
- Location
- New Hampshire
Looks like those welds could use a do over. That position is not ideal at all and that looks like flux wire which can make an extremely messy weld. As much force radius arms put on the brackets i would pull it out and weld again in a better position.
Also, were you out on the trail with your sway bar still attached???
Thanks for the feedback. The welds seem to hold up fine. The position is good, exactly where the stock ones were, same angle. These are brackets made for the Dana 35. We measured and compared, so position wise these are good. Ill be getting new axles in the future, and these should be fine until then.
And yes, sometimes I'll go off road with the sway bar attached, if I don't feel I need the extra articulation.