dana 60 rear disc

[ipkyss]

Could someone please give me the part numbers for the parts needed. I had them, and lost them.

The rotors I have are from a 85 1 ton chevy front.
calipers are 85 1/2 ton along with pads.
brackets for 1/2 ton calipers from poly performance.

The rotor is about 1/8" too wide to fit between the pads... I thought these were the parts I needed. If I can't figure out anything else, I will just have the rotor tuned down a little. I played the pull the parts off the self and check at the local parts store today. This was as close as I could get.

 

[YXwhenUcanFAB?]

When i did my 60's i used the calipers and rotors off of a 76-77 chevy 3/4 K30 4x4 front. bolted on, work great.

 

[YXwhenUcanFAB?]

JUst re-read you post. Ihe 1 ton rotors are you problem, you need 3/4 ton.

 

[JeepFreak21]

When i did my 60's i used the calipers and rotors off of a 76-77 chevy 3/4 K30 4x4 front. bolted on, work great.

Same here.
Billy

 

[ipkyss]

I actual had everythig right. The right boxes with the wrong parts in them. I did list it wrong though it was 78 1 ton rotors, 85 1/2 ton pads and calipers. with brakets from poly.