Converting a manual bender to hydraulic

[Prepmech]

Found a good deal on a pro-tools bender, too good to pass up. How exactly do you go about converting them to hydraulic? Is there any way to run them straight hydraulic with a hand pump, or do you have to run them with air or electric?

 

[RCman]

Poly Performance has a kit for JMR or JD2/Pro-Tools benders:
http://www.polyperformance.com/shop/product.php?productid=2396&cat=87&page=1

I'm building my own Air/Hydro bender. Details here:
http://www.pirate4x4.com/forum/showthread.php?t=376183
http://www.gottrikes.com/AH_tubebender.htm

 

[Roxtar]

Search here:

http://www.offroadfabnet.com/forums/forumdisplay.php?f=95

Probably a hundred threads about doing this.

 

[Jeff 98XJ WI]

Found a good deal on a pro-tools bender, too good to pass up. How exactly do you go about converting them to hydraulic? Is there any way to run them straight hydraulic with a hand pump, or do you have to run them with air or electric?

So what's the good deal? Good deal for two perhaps? Jeff