Gil BullyKatz
NAXJA Forum User
- Location
- 2003UB313 Planet ERIS
Plan is to run a HP44 w/radius arms to a separate crossmember forward of the stocker similar to PeteM's setup...
Except I want to attach Currie's JJ's to the radius arm ends...
Bad juju to simply weld the joint to the threads at the end of the arm?
overkill to tap some dom, thread it on the arms, then weld it, AND then thread the JJ to the DOM?
Am I complicating a simple job?
Any of you running full width radius arm setups have any pros/cons on James Duff's urethane "C" bushings in 4° & 6.25°?
TIA
Except I want to attach Currie's JJ's to the radius arm ends...
Bad juju to simply weld the joint to the threads at the end of the arm?
overkill to tap some dom, thread it on the arms, then weld it, AND then thread the JJ to the DOM?
Am I complicating a simple job?
Any of you running full width radius arm setups have any pros/cons on James Duff's urethane "C" bushings in 4° & 6.25°?
TIA