rockjockphatts
NAXJA Forum User
- Location
- Minneapolis, MN
Searched and haven't found exactly what I'm looking for...so here goes
First: Best way to get the knuckles off the axle...Pickle fork (TRE type separator) or the brass hammer method (listed on madxj's site)??? Not sure which way to go? What about heat?
Second: I've seen many different ball joints listed online, which should I get? I've seen the pricey ones, seen the really cheap ones, there are some listed as kits at quadratec.com, there's another kit that I found searching here listed as spicer ball joints (although it doesn't state their quality). What have people put in?
It's a 98 stock setup.
Thanks everyone
First: Best way to get the knuckles off the axle...Pickle fork (TRE type separator) or the brass hammer method (listed on madxj's site)??? Not sure which way to go? What about heat?
Second: I've seen many different ball joints listed online, which should I get? I've seen the pricey ones, seen the really cheap ones, there are some listed as kits at quadratec.com, there's another kit that I found searching here listed as spicer ball joints (although it doesn't state their quality). What have people put in?
It's a 98 stock setup.
Thanks everyone