Ax15 front bearing snap ring won't fit

[Stantheman601]

Like the title says. Almost finshed with a rebuild. The front counter cluster snap ring fit right in place, but the main bearing snap ring won't go. The case has been bolted together and fits flush. Its #5 and #6 in the link below. I'm reading how to post pictures and links right now, so if this is wrong I'll correct it in the future.

http://tcase.rsgear.com/technical/diagrams/transmission-articles/aisin-warner-ax15.aspx

 

[RCP Phx]

Is the bearing new? There is also a chance that it is also directional?

 

[Stantheman601]

Thanks to everyone in advance! The bearing is new and directional. It only has one groove for the snap ring, so I know the direction is correct. I'm hoping once I shift through the gears it will "relax" into place. If not I guess I'll be taking it back apart.

 

[RCP Phx]

Also check to make sure the bearing is fully seating, could be a radius issue. Also the snap ring could be directional.

 

[Stantheman601]

I finally got it! I had to build a wooden stand to keep the transmission upright. A little love with a block of wood and a hammer did the trick. Thanks for taking the time RCP Phx.