GruDog
NAXJA Forum User
- Location
- Ft Bragg NC
I need to sell my 1996 Cherokee, 4.0l and AW4. The jeep has a Dana 60 rear (Disc brakes), Dana 44 front, 4.10 gears and limited slip rear. The suspension is a radius long arm front and leaf spring rear with about 6 inches of lift. The axles were swapped in with Ballistic Fabrication parts. Tires are 33x12.5x16 Super Swamper Boggers with decent tread left on 16x10 alloy wheels. The jeep runs great, brakes work, heater works even the ac works, it could use a recharge though. Custom front bumper with 6 mounts for 6" lights, 4 KC lights included.
**********Clean title in hand**************
The bad: Interior is rough, floor panels have surface rust (Carpet has been removed), headliner is sagging (I was going to remove it) Doors dont work well (rears dont open, fronts are removed but included). Needs new axle seals front and rear.
The project part: Steering needs to be fabricated, I have the Ballistic Fabrication 1 ton steering kit with one ton chevy TREs, brand new never used waiting to install, just need one ton chevy TRE inserts ($50) Needs a frame side trac bar mount, custom heim joint tracbar is there, just no mount, one can be purchased for around $100 or built for $50 Id do the work if you want, just need to sell.
I have driven the Jeep around 500 miles after the axle swap, it works well, on or off road. I was in the process of redoing a few things and now need money. Please the note, the Jeep is not a finished product, theres a bunch of little things I wanted to clean up. This would make an excellent base to work off of.
Obviously, The Jeep is not drive-able at the moment, you can start it, hear it run, move it forward and back test the brakes and T case. A trailer would be required.
Asking $3,000
Need to sell now, price negotiable. The only things I'd trade for is a clean Samurai plus cash or a nice 2 stroke MX bike plus cash preferably a CR250 or YZ250.
**********Clean title in hand**************
The bad: Interior is rough, floor panels have surface rust (Carpet has been removed), headliner is sagging (I was going to remove it) Doors dont work well (rears dont open, fronts are removed but included). Needs new axle seals front and rear.
The project part: Steering needs to be fabricated, I have the Ballistic Fabrication 1 ton steering kit with one ton chevy TREs, brand new never used waiting to install, just need one ton chevy TRE inserts ($50) Needs a frame side trac bar mount, custom heim joint tracbar is there, just no mount, one can be purchased for around $100 or built for $50 Id do the work if you want, just need to sell.
I have driven the Jeep around 500 miles after the axle swap, it works well, on or off road. I was in the process of redoing a few things and now need money. Please the note, the Jeep is not a finished product, theres a bunch of little things I wanted to clean up. This would make an excellent base to work off of.
Obviously, The Jeep is not drive-able at the moment, you can start it, hear it run, move it forward and back test the brakes and T case. A trailer would be required.
Asking $3,000
Need to sell now, price negotiable. The only things I'd trade for is a clean Samurai plus cash or a nice 2 stroke MX bike plus cash preferably a CR250 or YZ250.
Last edited:
