Recent content by xjhal

yea,a little to far for me.thanks for the reply though

looking to convert my 2 door to maual crank windows and manual.locks.I don't care about condition of doors or glass,just the mechanicals/guts.Hopefully in ct or western mass. you can also call me at 860 978 7152.thanks Hal

Looking for a good trans for my friends moms 96.They already put in a jy one that was shot so we need a definite good one.Preferably one you have driven and know for sure is good.Cash in hand.Were located in hartford ct area so hopefully not too far. 860 978 7152..call or text is the best way...

like title says stock rear bumper for 96 and down.cash in hand

Looking for drivers side headlight bezel for xj wagoneer,the ones with 4 headlights.I need the bezel and signal lens.Cash in hand,need it soon. 860 978 7152

Ill take it.Call me at 860 978 7152 Hal.I can pick it up after work tomorow,or this weekend.

I shoulda asked you first ha..I'm intrested.I can come get it and help ya if you have any stuck transmission bolts lol

Sorry about that.3.55 gears.thanks though

Looking for a trac bar mount,frame side aftermarket but no rustys or rough country crap.rubicon express would be nice..I will also take a trac bar for a spare if ya got one also 29 spline 8.25,just need a temporary rear while I get my 44 finished Shocks for a 4.5 inch lift,getting new ones...

I also have a super skinny super swamper 35 or 36 inch variety,on a stock xj rim.I think its new or very close to new.I will look at it tomorow..50 bux either way

O yea location.Im in New Britain which is 10 minutes south of Hartford. I think I have a stack of fans so no problem there,shafts,I had a crapload,not sure whats left but def have some.

Looking to make some room.All of this must go.Lots of parts cheap aw4 trans pulled from a 1990 114k,i drove it,ran/shifted fine 150 bux aw4 trans pulled from a 1993 124k ran/shifted fine,was my backup trans 150 bux Black interior peices from 87 chief 4 door.all trim,seats,dash,console,rear...

Thanks man ,I appreciate it but I found one locally

the high/low switch love to melt,Ive already put two in mine

Ok,it started with a squeaky distributor.i pulled it out and slid a spare I had in,tightening the mounting bolt and snap,the mounting tab just snaps off. Ok,so I put the guts of my spare into the old housing go to reinstall it and snap the mounting tab off this one,damn.I was being extremely...