Recent content by UNDER CONSTRUCTION

I have a set of reman 258 rods i was going to use for my stroker. Interested? $40 = shipping

the deal fell through.. the ass left a deposit and never came back for the truck and I haven't herd from him since so it's up for sale again

Engine: 4.0 with 90 kon engine i believe 135 on the dile Trans: Stock auto Front diff: reenforced dana 30 297X joints stock 3.55 ( needs gears installed.. Have 4.88's Rear diff: dana 44 3.55 with powertrax no slip (have 4.88's that need to be installed) Bumpers: custom made front and rear Also...

$4500.00 firm! See the pictures below http://www.cardomain.com/memberpage/479208/2

Better then that is to get some tampons and stuff his tank full of them so when they swell up they block off the fuel to the enging and cause it to die... then if you let it sit for a little bit it wil start again and get sucked back into the pickup again and stall again.. It will drive him...

Looking for a power steering box. I believe any year will do on my 90

I got a YJ and I'm thinking about getting rid of my cherokee. Just curious what I could get for it or if any ones is interested ( i know it's going to be no where near what I have into it) Rustys 8" long arm kit 33x12.50x15 boggers on 15x8 street locks Skyjacker shocks front and rear Rear Dana...

i had the same problem with a rustys short add-a-leaf cracking in half and they over nighted me a new set for free. You should give it a shot

Are those stock pistons?

Droping the price to $200 shiped

I have plans for that but wasnt sure how I was going to lay it out. I think once i get the whole thing in there then I'll start adding diaginals. I appreciate all the feed back. At least I know I'm on the right track

I have the main hoop tied into the upper and lower seat belt mounting points and those upper tubes from the b to the c piller are just tacked into place right now. I am planing on doing the X bracing in between on the top but as I said I ran out of tube and this is as far as I have got so far...

I already have that done. You can't see it in the pictures but there is a crossmember that runs inderneth and connects to the rear bumper and frame and the rear hoop of the cage goes through the floor and mounts to that

Well i got started on my cage the other day but ran out of tubing. I did the main hoops in 1.50 .120 wall DOM and the rest in HREW. Once i can get a chance to get to the steel yard i will finish her up. Still have the front hoop to complete and tie it all together. Let me know what you guys...

i have 1 out of a 90 you pay the shipping you can have it