Recent content by Sub Zero

Super late checking back on this thread. Had these LEDs in for over a year before I sold my jeep. Never got flashed a single time. They were aimed properly and not shining in other driver's eyes.

Got tired of my cup holder falling off around turns with drinks in it. I wanted to countersink the holes to clean the look up, but I didn't have anything big enough. I wanted to use different hardware too, but the tube for the rear vent is in the way unless you pull the center console out...

There is tension there. You press down on the h4 faceplate and turn the base to index the "bulb"

I had posted before about space behind the headlights because I wanted to install the vleds h4 micro evolution headlight bulbs and was concerned about fitment. Just wanted to give an update incase anyone else was interested in doing this mod. The bulbs fit in my 94 without any cutting or...

Gearing*

Sounds pretty good to me, although I was thinking about going 4.10 so I can still run 75-80 down the interstate. I try not to take the jeep out of town, but sometimes I don't really have a choice and it's nice to be able to keep up with traffic. I think either hearing will be waaaaay better than...

Mainly primitive dirt roads and some sandy washes, but there are a few spots that get pretty rocky. I can make it everywhere I need to go right now, but I have banged up my axles and driveshaft a couple of times. I really need to regear as is, I've got a manual trans with the 3.07 gears

I should also mention that I'm on shortarms and don't have swaybar discos so I don't have a ton of flex

I'm really starting to lean pretty hard towards trimmed with 33s, are you bumpstopped as well?

My jeep basically gets driven to work and used for my hunting rig. I really just need more ground clearance than anything

That looks really good. Any idea how much sheetmetal you cut off?

I'd like to get a front bumper eventually, but I have no problem with trimming the bumper end caps for now 8f needed

I'm really on the fence about cutting the fenders. I know I could get away with 33s if I end up cutting them, but I kinda like the look of the stock flares