Recent content by sinat01

Ill have to check into it. The ones I have now are the crown 7 layer or something like that. But when I installed them I was at 3.5" lift and short arm lol not 4.5" and 3 linked. Brake lines tend to make good limit straps once or twice.

So 1999 2dr XJ 4.5" lift om 35s 3 link front Boostwerks shock towers rear w/leafs. I am wanting to go to a rear 4 link from IRO to match my front 3 link. I also want to swap to coil overs for the rear. What is the best way to figure out spring rates to match the amount of lift I currently...

So 99 2dr, Issue I am having is about a year ago I bounced my jeep off of a guardrail and cracked the frame between my rear and mid frame stiffeners, right where the front bolt is for the leaf spring. the jeep had sat and the spot ended up rusting between the two. I planned on cutting out the...

The CV axles are nice for the reasons mentioned above. I run them with 35s and a LSD on mine and haven't broken one yet. My buddy has a similar setup and has broken a few but he just warranty swaps them at autozone and keeps spare shafts with him.

When my AX15 made a noise similar to this it ended up being the input and output bearings. I know you had just replaced them but thats the closest suggestion i have. I run redline MTL, Stock AX15 and 231 with a SYE kit. had a shop put a clutch in and they didnt get the trans seated correctly and...

instead of the Currie go synergy. similar setup, except you can replace all the ends, whereas the curry setup still has the draglink as one piece Sent from my SM-G930P using Tapatalk

I have a $70 Ebay manifold. and it's been solid so far. 10yr warranty Sent from my SM-G930P using Tapatalk

I had mine for just over a year and it cracked. when I took it off and looked at it, almost every major weld had cracked on the header

Check out the synergy setup

hrmm there are other places that make them, just don't remember the names right off hand. the issue id have with a lot of cages is clutch access

I think DnC make a nice cage kit for XJs but its welded in, one of my friends has the rockhard cage in her JKU and its nice. id still rather have a welded in cage

I still have the stock HPD30 and 8.25. hrmm Also I was searching Ebay for a 241 and are the 241DHD and 241D geared the same? they come out of the dodge trucks

I have a Titan 4.0 with a stage 1 elgin cam in it. 16k miles so far with no issues

ok, Thank ya for clarifying

Dang. wonder if there is a way around that Sent from my SM-G930P using Tapatalk