Recent content by rarreola

I had the same problem until I changed the old TPS connector to the ECU.

in fact, it´s only one line wich go to the air box. there is no adverse efect to the engine.

I just deleted them

yes, you do. see this thread. http://www.naxja.org/forum/showthread.php?t=1018852

they function diferent, the renix has to be calibrated, the HO is fixed.

Maybe your friend is using a pressure cap grater than 16 lbs.

I did it in my 88 non-c clip and you dont have to take out the carrier. Just need to slip the copilot axle a litle bit out.

excellent, now climb hills more freely. On low: more throttle response, jump faster. On midium: Normal, little difference. On high: More power.

I will bore the intake manifold when stroke it, right now is 62mm. the pics are in your thread. http://www.naxja.org/forum/showthread.php?p=244773923#post244773923

It´s a Valuecraft VA7730 , afaik Ford Mustang air filter with a 3" opening: (Ford Motorcraft Air Filter FA-1616)

I made a small hole with a drill in the accelerator linkage bracket so it can pass a wire and tie to the tb pulley . Another modification that has to do is relocate the MAP sensor vacuum. I join it together with the ventilation´s vacuum hose. There are several vortec´s bonnets, the S-10...

Another important point is the iac valve. We use the same one that comes with the Renix but with some modifications. The head of the Renix iac is smaller than the vortec, but only use the vortec pintle . You can unscrew the pintle with a little DW40 help. Also I put 3 O-rings for a better...

This is the custom aluminum base. The measurements are 4 "x4.5" x1 ". I drill a breathing window so the iac valve can control idle. The bore is 62mm. The allen head bolt at the renix base is 3/8" x1". This part is the most complicated because it requires finding a way to match...

how to sawp the throttle body 52mm Renix 4.0 1987-1990 by one of GM vortec 4.3 1996-2002 70mm Material used: 1 GM Vortec tb 4.3 1996-2002 (without sensors). 1 vortec S-10 bonnet 1 used Vortec iac valve, does not matter if it works, GM # 17,113,209, AC DELCO # 217-435 what is needed is...

You can use your renix stock air box with a cone air filter and some 3" pvc Then add some air from firewall Cancel the front air vent If You need to get into shallow water And some cheap heat shield Also, with paper air filter.