Recent content by njedgexj

batt is less than a ys old..i def will check with a more accurate meter and see whats goin on..all cables are 0 guage welding wire.all ends are properly crimped and heat shrinked.i did notice an improvement from starting and when all my lights, radio,heat is on with the new cables.so they are...

yes i replaced with stock ones..battery is a yellow top..the winch is under 3 yrs old..doesnt it gets used periodicly..does not seem like brake is sticking i will chech all connections and clean up anything that looks fuzzy..winch is directlly connected to batt..i know many ppl with the same or...

when i am using my m8000 my voltage will drop below 9 and my check guages comes on..even if i have my foot on the gas to ramp up the rpms..after 30 secs or so voltage will return to normal..then does it again, and again till im done winching..i have replaced 2 alternators with no effect..all my...

hey didnt see u post ur number till tonight..next time i head down ill give u a shout

i will be at the ranger station at 9 meeting some ppl..we could def help ya out...how far is atco from the ranger station

ill be heading down sat morn..and meeting up sunday with some friends at the atsion ranger station

goin to wharton to do some wheeling and camping..anyone else gonna be in the area

hey JoeShmo i think i saw you on the parkway on thanksgiving...right after a toll?? i have a flat black 2000

i have about 6-1/2" lift with a hack and tap, and my front ds in the rear its working fine.

its not too loud...has a nice sound for a 4 cylinder...i might make a new exhaust during the winter, along with a jocky shift and foot clutch...i made the rigid frame using some parts of the 550 frame....i have a 70 cb450 that i might start on during the winter also...might go the cafe route...

thanks...it rides fairly well..alittle bouncy even with the springer seat..tracks straight, does not make tight turns tho...but no biggie..ill have a few mor pics tomorrow..gotta get a battery for it and install my air filters..

just finished this on monday...it was a bone stock 1978 cb550...what do ya think...

try por 15...works good on rust...

yeah, thats what i did too..cheap, easy...so far no problems...

congrats....