Recent content by Luggz

I have one out of a 99 Cherokee..90k miles...500.00 plus shipping

TTT

OK o.b.o pm me if intrested...Thanks

Complete dana 44 drum to drum trac-loc 3.55 gears out of a Cherokee 400.00 firm..Located in Michigan..

Dana 44 complete drum to drum track-loc 3.55 gears 400 firm..

Very easy install..

I have been told that i could swap a passenger side axle shaft out of a late moldel dana 30 (non disco) into a disco style dana 30 to eliminate the stupid discconect..Has anyone done this?Is there any mods that have to be done???Thanks in advace folks!

Jesus thats what 10 beers will get ya sorry...LOL glad someone seen the humor in it!

What year are the 4.10's for???99 and up??Rahter doed the pionion use a crush spacer or shims?

There where not reverse cut ones... I have a buddy that has a set of gears that i thought would work but then i read along and i see that the older style axles use shims on the pinion and the newer style 99 and up axles use a crush spacer on the pinion..Does anyone one know this to be true and...

I have the 242 t-case...Should be the same though thanks for the fast input guys!!!

Heya everyone i have a quick qeation about swappiung gears out..I ordered 4.11's for my rig and got them but the fronts are the wrong ones i was wondering if i could go ahead and install the rear gears and just not run in 4x4 until i get my new ones for the front.Hence i would leave the 3.55's...

Just ran out and took a look and they are fine...They are clunking where the joint screws in...

Anyone have one of these???I have been having a problem with it clunnking on the joints and have called them a number of times to have them tell me it's adjusted wrong..Alignment is good and the length on the arms are all the same...What gives???

I have a ECM out of my 99 XJ i don't need anymore...$65.00 plus shipping