Recent content by jester1341

So I got a 20$ WJ evic off eBay in alright shape sold as “untested” so I assume it doesn’t work, but more importantly did some reading and found out the temp sender is wired different in the XJ and WJ(of course). The EVIC is apparently fed by a signal wire in the OBDII bus that isn’t even wired...

Nowhere near, I’m outside martinsburg in Berkeley county, might as well be Maryland. :D

What size lift are you doing this on and how much rear lift did you lose? I cannot imagine very much, but no doubt lost a little.

I prefer to have a factory fob instead of aftermarket, just cause. Roboto, that’s tempting but if I cut mine, I was thinking I’d have the compartments and all rear of the sunroof, in other words I’d still plan to use the entire thing. I’d much prefer the WJ route, wonder if I can use one with...

For starters, I did search and didn’t really find much to answer what I’m thinking, although I did find Mr Roboto’s post and see someone out there has actually cut down a OHC.🤔 So, I have an OHC that I acquired before buying a 2001 XJ with a sunroof, actually guy didn’t even mention it in the...

I know this is an OLD thread, but I was wondering if there was a way to use the fixed yoke off the 208 or if there is any reason for me to buy one. I found one on Craig'slist for a hundred bux. Would I be better of looking for a 231c to upgrade my 231j?? John

They look like the devices plumbers use to block off and test pipes, if so I imagine a plumbing or home improvement store in the plumbing isle. Is that what it is?, and the proper term is bellows? Like a blacksmith's tool? John

I'm not 100% sure if it goes anywhere after the barbed conector in the unibody rail.... In any light check this thread out for ideas to vent :-) Venting diffs, trans, and xfer case John

Just out of curiosity..... Has anybody told dynomax they have a bend in there for no reason?.... Other than to piss me off, of course. John

I was afraid that was gonna be the answer.... I wanna keep the polished tip, guess I'll just weld in a straight section. John

I searched here and google about the dynomax catback exhaust for my nearly stock Cherokee before I bought it, and after installing it and not being satisfied because the final kick in the tailpipe section causes it to rattle/vibrate against my shackle(lift shackle). I know lots of people run...

how much for the borla?? and the front skid?? john

not interested myself but is the chryo a 27 or 29 spline, also is the D30 a HP?? john

i like the 1/2 red 1/2 clear pre97 set on shmEbay but 90bux and 25bux to ship....ill keep mine, cuz i WILL just break um....muhahaha john

deffinatlly if you go by someone elses measurement you could end up with a DS too short or too long or maybe an acceptable length but you measuring means only buying it once for sure good luck, john