Recent content by JeEpXjSaM

bump any updates?

For comparison here is how my alarm on my xj is currently wired. This is much simpler to wire, but as soon as you shut the door the alarm shuts off. Possibly allowing a thief to break the window, pop the hood, and disconnect you battery (i had this happen once, the a** stole my $300 cb,sub n...

Time for an update, i finally got the led strip lights here they are lit up installed now all i gotta do is wait fora warmer day to put it back in my xj

Here is the wiring diagram i drew up in paint. The reason terminals 87 and 85 of the alarm relay are connected is so that the alarm stays on even if the door is closed. until you ether push the trunk button on your remote starter or until you push the manual silence button. So what do you...

if you do go that route make sure that it uses more than just the factory bumper mounts. or your trailer and bumper may pass you on the highway.ask me how i know.

heres a wire color code red-org tracer 12v hot drk green-red left turn whit-tan brake brown- red right turn light blue from trailer brake controller brown-light green revers lights brown-yellow tail lights if i am wrong on any of the wire colors feel free to correct me

do a continuity check, youll have to make a long jumper wire from the blue wire to the cargo area and there should be an unused plug behind the driver side panel in the cargo area. but make sure to unhook you battery first, because there is a 12v hot wire in that harness. also the plug should...

i figured it out i found a diagram for a 93 and i got it to work i will post my own wiring diagram and pic/video later when i have some more time.

thats not what i want to do. i am makeing my own harness like the factory with relays. as i have all the supplies but no money (laid off) and tons of free time

does anyone have a wiring diagram for the factory trailer wiring from the body harness for an 89 xj?

looks like the ac temp sensor to me

check the fusible link by the batt. i had the same problem on my 90 xj spent 5 hours looking for the problem (was my first truck and i didnt know alot about wireing at the time) i then gave up and asked my dad(hes been working on car for 40+ years) to look at it. in less than a minute he found...

it was fairly easy for me, but i was always good at taking stuff apart and putting it back together. i rebuilt the pump also i just didnt power wash it (i forgot)

sorry i didn't get any pics of me putting the valve body back together or back on my hands where covered in tranny fluid, it took both of my hands to keep all the little balls and such in place. my buddy who i borrowed the camera from said "do not get any grease or oil on my camera" bell...

i took these pics so i could remember where all the little balls and such went