Recent content by jcroffroad

Hey everyone, if you haven't seen yet, we are petitioning to get Axial to develop and release an RC crawler of the 97+ body Cherokee! https://www.youtube.com/watch?v=gPD2RndNITk We collected a ton of signatures on our petition so far, but we are going to need more to make this happen! Next...

RIP Aaron. Prayers sent to your family and friends. :(

An XJ history lesson and a ‪RealHawk‬ build overview all rolled into one. It's like Cherokee Christmas! F-qG7bPdkEM

Hey everyone! We just released information our 2014 Swap meet! Hope you guys can make it out! http://www.jcroffroad.com/swapmeet.html Facebook event page: https://www.facebook.com/events/246114228923676/

Thanks guys. It's been a fun process with this move! Hopefully it will really benefit the customers a lot! Installations are back, we have a showroom and it should make manufacturing faster!

Thank you to everyone that made it out for our open house last Saturday! It was a great turnout and a lot of fun! A special thanks to Two Trackers, GLFWDA, Sundowners, 4Given4x4 and Michiana Jeep Clubs for coming out! For those of you that didn't make it out, here's a quick web tour of our new...

Parking Map for Saturday:

That's the plan! Amongst other things!

Registration is up for the 4x4 Show at our open house on November 9th. The winner of each category will receive these cool trophies hot off the plasma, a gift cert, plus JCR swag. You won't want to miss it! If you are interested, register here ASAP...

Come and see the new JcrOffroad Headquarters! Bring your truck for the show and shine, nab some food off the grill, and see the new digs. We will have a bounce house for the kids, giveaways, and award fan favorite Jeeps a few categories deep. We will also do a virtual open house with photos...

If anyone is interested, please contact us to fill out an application. Pay is $10-13 per hour based on experience. The right person could be worth a little more. We have Health Insurance, 401k, vacation and holiday days. If you are interested, please contact [email protected] for an...

We use the same plates for all of our box sliders, sometimes they end up with one hole over a frame hole as you have seen. It's not a big deal. Three bolts per plate is more than enough.

Drill the hole where you assume it will need to be once it's pulled down, then put a bolt or something similar in that hole to pull or hammer down? I have an attachment on a slide hammer that I can bolt to a flat seam to pull things like that. Not having one bolt on the pinch seam shouldn't be...

Ohhhh! Ok good! :clap:

Is this referring to us?!