Recent content by Ekacpuc

Awesome responses! I’m at work now but will do the key method for codes. When I did tps I reset the computer and no change. I’ve been tracing wiring looking for bad connectors and burned wires and will go over it again. I just double checked for vac leaks and none so far. No cat on it to...

Why the IAC? I’ve checked for vacuum leaks. Echlin brand is only thing available here. I can order online if needed but “junkyard” here doesn’t have Jeeps. It’s not a real junkyard lol.

Oh and I have the attachment to hook up my gauge to check the fuel pressure. Looks like about a week out though.. it has a lot of pressure when running, good pressure right after shut down but seems pretty low a min or so after shut down. I figure it could be injectors (not leaking out of sides)...

I have a 93 with a 4.0 and an automatic and have a couple strange issues. Every now and then after startup it won’t rev past 1000 rpm. It hits 1000 and drops very quickly back down to idle (around 500) then revs back up quickly. It’s like hitting hard rev limiter, happens very quickly load or...

It’s a dimmer switch. One or two screws and it pops right off. Swapping it out. I doubt it but I was hoping it would help my wipers park normal.

Also the wipers park in the vertical position. There’s also a black two prong wire that is on the new column but not the old.. Really if I can get the wipers to park where they should i wouldn’t care about anything else because everything else seems to work. Jeep column failed, old lady lost...

Yes. The only difference I see is cruise control (wasn’t on old column) and the one less prong. I would have thought since the new column had a cruise control it would be the one with the extra prong.

I have a 93 xj that I replaced the column on. The plug that attaches to the rod for the windshield wiper switch on the rebuilt column has 3 prongs. The old column and matching plug on the vehicle has 4. What’s the extra prong for and what is the work around if any? Only issue so far is the...

I have a 93 Cherokee automatic with the shifter on the floor. Is it a direct swap to go from the tilt column to non tilt for the same year? That’s all I need to know. Not looking to debate why. ;-)

Murray

My first post here but I've been lurking awhile. Replaced water pump, thermostat and flushed cooling system. I did get a new pump from orielly and suspect that it is the culprit. Did burp the car after all the work. Overheats while cruising but cools down when revs increase. I suspected a fan...