Recent content by davidlepsch

  1. D

    99+ Intake Swap Dyno Results...

    im got a 98 xj and just bought a 99 4.0 motor and was wondeirng what type of gains i would see from putting the the 99 intake on my 98 xj. I do have a 62.5 t.b., firepower igintion kit, intake, exhast, edge trail jammer module too. any thoughts would be helpfull. and i plan on making the 99...
  2. D

    bored throttle body

    not to be too off topic but i ended up getting a edge products module from the trail jammer kit for a 62mm t.b., have a custom intake, and a 62.5mm t.b. I havent taken my spark plugs out yet to see waht color they are but what does the programmer exactly do besides just lie to the computer? and...
  3. D

    poormans 4.5 stroker?? Help!?!

    ok so i think im going to use 87-90 crankshaft, the 4.2 rods, 4.0 bearings, .020 pistons, new rings and all arp bolts. What kind of power numbers would i be looking at and what about motor longevity and mopar h.d. oil pumps or hi vol. pumps?
  4. D

    poormans 4.5 stroker?? Help!?!

    what year 4.2 crank, 4.2 connecting rods, bearings, .020 pistons, head gasket, new bolts? should i use? and is there any other modifications needed to put this all together or is it just direct bolt in/ons ? Should I do anything to the head thats cheap enough while its off too, besides clean it...
  5. D

    poormans 4.5 stroker?? Help!?!

    Ok then the motor has 164k on it and i could bore it out .030" im looking to run probably some 91 octane pump gas. I'm going to go with the 4.2 rods. I'm trying to make it a daily driver if at all possilble and it will be going in a 98 xj with mods listed above, so its going to be in obd2 w/ the...
  6. D

    poormans 4.5 stroker?? Help!?!

    Ok then the motor has 164k on it and i could bore it out .030" im looking to run probably some 91 octane pump gas. I'm going to go with the 4.2 rods. I'm trying to make it a daily driver if at all possilble and it will be going in a 98 xj with mods listed above, so its going to be in obd2 w/ the...
  7. D

    poormans 4.5 stroker?? Help!?!

    i just bought a 99 4.0 motor that i plan on putting a 258 crank and rods into. I already have a full ignition kit, 62.5mm t.b., cat back exhaust, intake. I want to run pump gas and make this motor with as little money as possible. Is it possible to get a good crank out of a 258 with...
Back
Top