Recent content by Anothername

So I was thinking about switching to some Wj knuckles for the front brakes. However, I have the 1 ton crossover steering, and an adjustable track bar. The question is, can I run the standard xj crossover with the Wj knuckles? Or is their some binding doing that?

Also getting no bus

So here is my issue. Ive been working on the jeep a little and managed to do two things. I welded on a second battery tray, and I pulled my ac evaporator from the dash. Now, when I go to start the jeep it just turns over and gives me the P1694 code. Additional info, I did cross feed the battery...

So they don’t make a sound when I try and lock or unlock. But they will cycle when I pull the power and reapply power. Everything will unlock I do have keyless entry Yes, the locks aren’t binding or anything. I can manually lock all the doors from the inside no problem. And I can unlock...

So I can’t figure this out for the life of me. I have a 01 xj, with auto locks. Problem is they don’t work. I’ve replaced both of the switches in the doors, both driver and passenger. I’ve checked the continuity in the lines and they don’t have any brakes. I’ve looked at the fuses and they are...

01, auto, and I have a tilt column

So I do have a lift on my jeep, and once I start to get up to highway speeds I’ve found that my steering column rattles. If I push down on it, it stops. I’m not sure what I should do in regards to fixing it. Have any of you guys had this issue? It’s driving me crazy