Recent content by anaheimxj

anyone in Idaho or Montana want to chime in?

so to clarify it to the best of my understanding; 1) complete all front end work EXCEPT track bar. 2) install track bar at NON-AXLE mount point. 3) adjust axle to center of vehicle by cycling the steering wheel, from lock to lock then back to center. center is determined by measurements from...

Thank you. I was talking about the nonbar pin type. I have done the bar pin elimination already.

blue wrench=weld, aaaaahhhhh

can the bushings on a rancho 9000 be replaced? if so, how can i go about it? do i need to have a shop do this? any tips? thanx

blue wrench?

everyone that has had anything to say, says to NOT go to the electric fan!!!!! instead "fix" your cooling problem. there is even a write-up on this. I used a flexilite 110 with their adjustable thermostat. it is a little larger tha your mechanical set-up and some work and time is involved in...

could you do the schematic? I think that would help clear up most of the questions. Thank you.

as somebody stated, it depends on the state. Also it depends on many other factors including the company, agent/broker, wickedness and so on. Also and very IMPORTANT, if they don't know it's on there they can and have succeded in not covering the modifications. This includes not replacing...

Rich, I am looking in my FSM in the electrical section and cannot find a specified rating for the relays. If I read your post right PDC fuse #5 is rated at 40 amps. Is that all that fuse is connected to? I agree that is a large wattage draw. I was thinking more along the 20 amp at most range...

what is the rubicon short cut trail(road)? who did you get a permit from and why?

you would need to use an ammeter or take it to an auto electric place or have somebody knowledgeable meter it for you. you might be able to get it from the service manual or from a service guy at your local stealership.

thank you for the reply. I have a couple more questions if you don't mind.? 1) when you say "existing hot lead to the fan" do you mean on the PDC/EDU side of the plug or the fan side of the plug? 2) do you connect the ground wire from the PDC to anything? 3) are you bypassing the fan...

A buddy of mine is moving to the Spokane area and wanted to know if there is any 4 whellin in the area. We have done the hard core stuff, but mostly enjoy the moderate stuff. Can anyone give him an idea of the amount and type of wheelin where he is going? Thank You

WILL THIS WORK FOR A 1996 CHEROKEE AS WELL? ALSO, WHAT TYPE OF SWITCH DO I NEED? SINGLE, DOUBLE POLE? SINGLE, DOUBLE THROW? I KNOW JUST ENOUGH TO BE DANGEROUS AND DON'T WANT TO FRY ANYTHING OR MAKE MULTIPLE TRIPS TO THE STORE. THANK YOU.