Recent content by 99NCXJ

If anyone is interested in a tire carrier similar to this one I'd be happy to make some more. Even some that quick disconnect like stated above. Just shoot me an email. I don't get over here on this site much. Justinco2 (at) bellsouth.net

price drop. 150.00

selling a rear D44 from a grand waggy. centered pumkin, stock gears (2.72 i belive) nice condition. Everything is there except for the drums. 200.00 obo. I don't get on here much so the best way to contact me is at [email protected]

Thats a pretty good price for a 23 spline with SYE already installed. I belive thats what I sold mine for, or maybe more.

here are pics of the driveshaft for those who asked.

20.00 for UPS ground, 2 days in transit.

32.75" collapsed 37" extended this is from mounting surface to mounting surface Noticed that the grease zerk is gone (must have lost a fight to a rock at one point in time) but I should have one I can put back in.

didn't get to measure it last night. I'll get to it tonight.

I'll get some measurements and take some pics in a little bit.

got a slightly used Tom Woods rear drive shaft for sale. CV style shaft with gold seal u joint. I bought it new about a year ago or so and wheeled it several times on my XJ. Im swapping in Toyota axles and will be building my own shafts. I paid over 300.00 for it new. Asking 200.00...

no body parts left.

CB sent out today. I actually sent you a newer cobra cb i had in the cabinet. Its the same model as what was in this 92 but this one was not as old. Saved me a trip out to the shop and you get a newer unit!

Yes, only have the parts listed above. Header pannel/grill, seats sold

Parting out whats left of a 1992 Jeep Cherokee Laredo 4.0L 118k or so miles. 300.00 a/c compressor 65.00 alternator 40.00 recently replaced starter 45.00 Like new radiator 100.00 A/C condensor 45.00 tranny cooler 25.00 front seats, grey cloth, one needs some cleaning 20.00 each SALE PENDING...

i've got several on the shelf too. I'd be willing to part with one. I'll need collapsed measurement so i can make sure i pull the right one. PM me if interested.